Thursday, December 12, 2013

Range Day #1 12/12/14

Finally, like a boy on Christmas I was at the Range with my new shiny 6.5 CM. Dennis met me and gave a few more sage tips, and it was time for the first shots to ring out. I was shooting a large silhouette target at 100 yards to (get on paper) 1st shot wasn't bad. This isn't blow by blow, and will be more technical with future outings. For the first one I wanted to set the scene a little better. I was shooting the gun as I would in field rather then FI style shooting set up. I used a Harris 6-9" bi-pod and a squeeze bag to steady the back. I originally was using a lead sled, but that sucked so I got rid of it.

Range Conditions:
Faribult shooting range. 100 & 200 yard targets
Temp: 18 F
Wind 2-0 very calm
Alt. 965 “shooter” app”
Bar. 30.27 inHG “shooter” app
Humidity 75% “shooter” ap
Lat. 44.803
Azimuth 354
look angle 80
( didn't bring laser thermo, so I don't know ammo temp. 

AMMO: Hornady 6.5MM Creedmoor 140 Grain A-max factory load. 
I don't have a Chronometer yet so I'm not sure of the velocity. I suspect it is around 2850 ft/sec. 

Zero settings 6.5 CM
shot with moderate dirty bore 10 shots fired from builder
0=100
.5 Mil up= 200  (this matched the Hornady ballistic data exactly) :-) 
4.25 inch drop from 100-200

Zero settings .308
shot with dirty bore 30-40 shots between cleaning
0=100
2.3 MOA up = 200 yards. 
9 inch drop from 100-200 yards. 


1st Shots were centered striking just right of the target. A little adjustment and I was on, then a bit more tweaking and prelim initial zero set. Now, 18 degrees is far from the usual temp. So I'll see how temp affects zero, at these short distances, it should be much, but I have to keep track for later when it matters. Due to the zero stop on the Steiner, I had to make some adjustments to move down a bit. 

100 yards initial zero, first shots right. The other marking are from me sighting in the .308. 


After I reset the zero stop, I took a few more shots and got set where I wanted for right now. For these shots I changed my shooting rest, and used a bi-pod and bag. I also adjusted the zero stop down, then back up a bit. Felt pretty good, and precise. 

100 yard 2nd zero





Next I moved to the 200 yard range. For the first shot I lined up on the center, and fired 4 1/4 drop as expected. 
I looked using the mil dots and it appeared 1 mil low so I adjusted a full mil, which went well high whoop's! 

6.5 CM 4 1/4 drop on first shot. The .308 put 2 holes next to each other to right of bullseye

After making a few adjustments, dropping to .5 mil up. I was on!!

200 yrd zero. .5 mil up and there we go. 


While allowing the 6.5 CM to cool between shots I worked with the .308 and got that shooting two in pretty much the same hole (I made a slight adjustment down) 





Learning art of long range shooting.

While at the range I was fortunate enough to run into a true gentleman (and I use the term loosely J/K) :-) named Dennis, who is an experienced long range shooter. I was shooting a .308 Howa and while doing ok (or so I thought) at 100 yards, 300 yards, & 400 yards (one dinger off a 10" gong)…200 yards was giving me fits. So I started up a conversation, and quickly was following Dennis and his range buddy Sam up to the 600 yard range where my interest was immediately peaked, as I watched them drill 1" targets at 600 yards. Impressed and humbled would have been the first words to come to my mind. I knew I wanted to learn to own that distance. Over the course of a couple months, lot's of phone calls, internet time, youtube, more calls, even more emails, I finally settled on my baby. A 6.5MM Creedmore would be my Huckleberry. It would be built of a Brux Barrel, Jewel Trigger, H-S Precision Stock, 20 Moa rail, with a blueprinted Rem 700 Action that Dennis found for me. Then it was time for the builder, and Dennis knew just the right guy for the job, another gentleman named Dick Eberle out of Lamour, ND (very near where I grew up). Pieces ordered, deals made, and my endeavorer was under way. 

I realized that if I was going to really focus on learning the art of long range precision shooting, having a bunch of guns that I half knew how to shoot would be pointless. It was difficult, but a parted ways with the majority of my collection to raise money to build a fine well crafted rifle that would suit my needs. It also cleared away the distractions of other guns. So here goes the journey…...



This is Dick Eberle He built the 6.5mm Creedmoore for me

These are the maiden groups as the 6.5CM took it's first breath

And and 2nd group. 



Optics was the next big decision. I sold more of my collections and got a Steiner Military 4x16x50 scope for a good deal off a guy on snipers hide. Yeah me :-)


My Baby fully dressed.

And go!! I'm going to list information and results from each range day to help me build a good bullet and rifle profile to help shape my shots and decisions at later times. I also want to give credit to a guy named REX at sniper101 on youtube, he is an artist and true genius at breaking down complex information for little birdies like me to chew up